Binary Input Option Boards; Option Boards For Analogue Outputs; Binary Output Option Boards; Option Boards For Power Supply Outputs - Ecolab Versatronic Instrucciones De Servicio

Ocultar thumbs Ver también para Versatronic:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

13.9

Binary input option boards

Max. number of retrofittable
binary inputs
Max. 2 option boards with 3
binary inputs

13.10 Option boards for analogue outputs

Signal type
Voltage signal
Current signal
13.11

Binary output option boards

Option card
Relay output 2-way N/O
Relay output 1-way
change-over contact
Triac semiconductor relay
Semiconductor relay SSRs
PhotoMOS®e
Logic output 0/12 V
Logic output 0/22 V
1
(
) The maximum current capacity of the contacts must not be exceeded.
(
2
) A combination of AC voltage and low voltage protection circuits to a 2-way normally open option is not allowed.
3
) A Varistor protects the Triac against excessive voltages, such as may occur during switching operations.
(
(
4
) Current limiting by the logic output of the device

13.12 Option boards for power supply outputs

Name
DC 24 V power supply for
external transmitter (
± 5 V DC power supply (e.g.
for ISFET pH sensors)
1
(
) All the outputs in this table are on an option board for power supply outputs. A device can have no more than one such an option
board installed.
Max. pulse rate
1 Hz
Permissible load
Signal range
resistance
0 to 10 V
> 500Ω
0/4 to 20 mA
< 450Ω
Switching output
2 no (
1
)
1 changeover
Switching output
with Triac (protected
by Varistor)
2
(
)
Switching output
with PhotoMOS®
High/low signal
High/low signal
Output voltage
DC 24 V +15 / -25%
1
)
DC -5 V ±15%
(intermediate terminals 3 and
4)
DC -5 V ± 15% (intermediate
terminals 5 and 4)
249
Min. pulse duration
On
Off
300 ms
300 ms
Accuracy
≤0,25 %
≤0,25 %
Current capacity
with resistive
load
Contact life
3 A at AC 250 V
150000 switching
cycles
1 A at AC 230 V
Wear-free
200 mA at 50 V DC
or 35 V AC
Wear-free
20 mA (
4
)
30 mA (4)
Wear-free
Current capacity
30 mA
150 mA
30 mA
Technical data
Signal type
Floating contact
Ambient
temperature
influence
= 100 ppm / K
= 100 ppm / K
Particularities
-
-
-
Voltage DC 50 V
AC 35 V
-
-
Connection
Screw terminals
417102269 Rev. 2-08.2020

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

255201

Tabla de contenido