Info; Connecting To The Device; Device Connection List - Ecolab Versatronic Instrucciones De Servicio

PC setup program
12.6.5

Info

About Setup
Displays information about the Setup program, including the version number.
The version number is important, for example on contact with the service hotline.
Registered licence numbers...
Lists all registered licence numbers and, where appropriate, the active options.
The license numbers and information about active options are important, for example on
contact with the service hotline.
Program folders...
Shows the different folders (directories) that are used on the hard drive or network from
the setup program. Clicking the button (right next to the folder path) to show the contents
of the folder.
Memory info
Shows the memory information. The memory information is intended for diagnostic
purposes. It is queried when needed by a service technician of the manufacturer.
12.7

Connecting to the device

This section describes the various ways to establish a connection between the Ecolab PC
Setup program and the device. You can connect via:
n LAN interface (HTTP or HTTP proxy)
n USB interface
The USB interface is not suitable for permanent connection because the
USB connector has no lock to protect it from unintentional removal.
An existing connection is required for the data transfer between the Ecolab PC Setup
program and system.
Open in the menu bar: Data transfer èConnect...
12.7.1

Device connection list

The device connection list includes all the devices for which a connection is already
configured. The user can add connections to new devices, change the properties of
existing connections (e.g. interface parameters) and remove connections.
417102269 Rev. 2-08.2020 200