Storage Management (Usb Flash Drive) - Ecolab Versatronic Instrucciones De Servicio

Event
n configured event (condition finished)
n Calibration stop/abort
n timer stop
n Wash contact stop
Manual mode controller OFF
n
n Controller Autotune complete
Comment added
n Daylight saving time
n No connection to an input module
n Configuration change
n Reset counters
n Reset flow rate measurement
n Acknowledge collective alarm
9.3

Storage management (USB flash drive)

Fig. 40: Memory manager
With the memory manager, the data transmission between the Ecolab 'Versatronic' is
done via a USB memory stick. To access the Memory Manager, close all open windows
and insert the USB flash drive into the USB host interface. The storage manager then
opens automatically. To access the menu items "USB -. Device Config", "Service data -
USB" and "software update" You must have the appropriate user rights.
By default, only Service users are authorised to do this.
Ä Chapter 9.1.1 'Passwords and user rights' on page 81.
See
93
Use
Symbol
No icon
417102269 Rev. 2-08.2020