Display Modes - salmson LRE Serie Manual De Instalación Y Puesta En Servicio

English
Actions
8.5

Display modes

Display test
max
min
2
Fig. 24: Display test
8.5.1 Display status page
8.5.2 Display menu mode
69
• Turn white button: Turn the white button or increase or decrease
settings or menu numbers.
• Press white button: Press the white button to activate a menu ele-
ment or confirm a change.
• Navigate: Perform the steps that follow to navigate in the menu to
the displayed menu number.
• Wait time: The remaining time (in seconds) is displayed on the value
display until the next state is reached automatically or manual input
can be made.
ON
• Set DIP switch to the OFF position: Set the DIP switch number "X"
under the housing cover to the OFF position.
X
ON
• Set DIP switch to the ON position: Set the DIP switch number "X"
under the housing cover to the OFF position.
X
As soon as the power supply of the electronic module has been estab-
lished, a two-second display test is carried out, during which all char-
acters on the display are shown (Fig. 24). Afterwards the status page
is displayed.
After interruption of the power supply, the module carries out various
shut-off functions. The display will be shown for the duration of this
process.
DANGER! Risk of fatal injury!
There can be electrical charges present in the display even if is
switched off.
• Observe general safety instructions!
The standard view on the display is the status page. The current set-
12.3
point is displayed in the number segments. Other settings are dis-
played using symbols.
NOTE
For dual pump operation, the operating mode is also shown in symbol
format on the status page ("Parallel operation" or "Main/reserve").
The display of the slave pump shows "SL".
The electronic module functions can be called via the menu structure.
The menu contains sub-menus on several levels.
The current menu level can be changed using "One level up" or
"One level down" menu items, for example, to change from menu
<4.1.0.0.> to <4.1.1.0>.
The menu structure is similar to structure of the chapters and sections
in these operating instructions: Section 8.5(.0.0) contains subsections
8.5.1(.0) and 8.5.2(.0); in the electronics module, menu <5.3.0.0>
contains menu sub-items <5.3.1.0> to <5.3.3.0>, etc.
The currently selected menu element can be identified by the menu
number on the display and the associated symbol.
Within a menu level, menu numbers can be selected sequentially by
turning the white button.
NOTE
If the white button is not operated for 30 seconds at any position in
menu mode, the display returns to the status page.
Pompes Salmson 04/2011