Battery Removal; Using The Machine - Tennant VLX Manual De Instrucciones

Check the engine oil level (see the chapter
"COMBUSTION ENGINE MAINTENANCE").
Climb onto the machine and adjust the seat as

BATTERY REMOVAL

Check that all the switches on the control panel
do not short-circuit the battery poles, do not
cause sparks and do not smoke, and proceed
as follows:
• disconnect the battery wiring and bridge
terminals from the battery poles.
•
the battery to the base of the machine.
• lift the batteries from the compartment
using suitable lifting equipment.

USING THE MACHINE

the display will show all zeros for about 3
seconds, after which the battery voltage value
will be shown.
START
O FF
Let at least three seconds pass after you have
again.
Check the battery charge shown on the
machine's display.
The display has two functions: Voltmeter and
Hour meter.
The voltmeter incorporates an undervoltage
shutdown function that automatically disables
all services except for drive when the battery
drops to a voltage of 20.5V (the BATTERY
display).
In this case, recharge the battery (see the
chapter "BATTERY MAINTENANCE AND
CHARGING" and the battery user manual).
can now resume.
start the engine.
EN 11