Electrical Connections - DITEC DMCS Instrucciones De Uso

1. DMCS SOFTWARE INSTALLATION
- To install the DMCS software, introduce the CD-ROM into
the computer, launch the SETUP.exe file and follow the
instructions
- To start the programme, select the link from the pro-
grammes bar or select the DMCS.EXE file.
Minimum system requirements. PC with Windows® 98/ME/
NT4/2000/XP operating system with 10 MB available hard disc
space and at least 32 MB of RAM.
2.

ELECTRICAL CONNECTIONS

Follow the connections indicated in fig. 1 for single automations
without operations selector.
Attention: make the connections with the computer switched off.
At least one COME operations selector must be connected for
the connection of electronic boards in a network.
Attention: the DMCS can only manage one redundant automa-
tion system (94R).
Maximum performance of the DMCS is obtained with the fol-
lowing versions (fig. 2):
- COME: version ≥ 0 or firmware upgrade;
- COM2: version ≥ 3;
- 94 electronic board: version ≥ 6 or firmware upgrade;
- 94R supervisor: version ≥ 1 or firmware upgrade;
- 99 electronic board: version ≥ 0 or firmware upgrade.
3. ELECTRONIC BOARDS NETWORK CONNECTIONS
The operating mode is the same for all automations connected
in a network that is set by the COME selector or with the DMCS
software.
Example fig. 3:
From one to four electronic boards can be managed with one
or two COME with this type of setup.
When the DMCS manages four automations, cut the resistance
marked [X] on the electronic boards [2], [3] and [4], if the DMCS
is permanently connected.
Example fig. 4:
From one to four electronic boards can be managed with one
or two COME with this type of setup.
When the DMCS manages four automations, cut the resistance
marked [X] on the electronic boards [2], [3], if the DMCS is
temporarily connected.
4. USB DRIVER INSTALLATION
- The peripheral device should be recognise by the system
when connected to the appropriate port of the computer.
- Once the peripheral device has been recognised by the sy-
stem, the new hardware installation guide with start, insert
the CD-ROM in order to load the driver for the peripheral
device.
- Select the CD-ROM drive (for example D:\).
- Select the string D:\Napdos\7000\756x\I-7561\.
- Complete the string based on the computer's operating
system.
- Select the correct driver SERWPL.INF and complete the in-
stallation procedure. Restart the computer if necessary.
- Check the serial COM port number assigned by the compu-
ter on the Control Panel - System - Hardware - Peripheral
devices manager - Ports - I-756X Converter.
- Indicate the number of the previously verified serial port
in the setup of the DMCS manager's serial port.
5. DMCS SOFTWARE FUNCTIONS
To understand the function and performance of the DMCS
software, start the programme and consult the on-line instruc-
tions .
5
GB
DMCS - IP1660