Shaft Alignment Tool - SKF TMEA 1P/2.5 Instrucciones De Uso

2.

SHAFT ALIGNMENT TOOL

The following components are included with the TMEA 1P tools:
• Display unit
• 2 measuring units with spirit levels
• 2 mechanical shaft fixtures
• 2 locking chains
• 2 extension chains
• 5 sets of shims
• Measuring tape
• Instructions for use
• Set of alignment reports (TMEA 1P/2.5 only)
• Carrying case
Additional components included with the TMEA 1PEx:
• Printer
• Charger
• Connection cable
• Spare paper roll
Fig. 5. Tool components
A Measuring unit (M)
B Sets of shims
C Measuring unit (S)
D Locking chain
TMEA 1P/2.5 / TMEA 1PEx
E Measuring tape
F Display unit
G Printer
Shaft Alignment Tools 11