Instructions For Use; Customising Of The System; Metric Or Imperial Sizes; Date And Time - SKF TMEA 1P/2.5 Instrucciones De Uso

3.

INSTRUCTIONS FOR USE

3.1

Customising of the system

3.1.1

Metric or imperial sizes

The tool is delivered with a pre-selection for measurements in mm.
In case you want to change into inches, press the minus sign
simultaneously to switching the tool on.
To revert back to mm press the plus sign when switching on.
The last setting will always be remembered.
3.1.2

Date and time

The date and time are preset. If they need to be changed, reset as
follows. Switch OFF the display unit. Connect the two measuring units.
Press the next button together with the ON button.
Date setting:
The date setting starts with the
year, followed by the month and
the day.
Enter the year by using the + and - buttons.
Confirm the year setting.
Proceed the same way to set the month and the day.
Time setting:
The time is shown in 24 hours
mode.
The time setting will start with hours, then minutes.
Adjust the hours by using the + and - buttons.
Confirm the hour setting.
Proceed the same way to set the minutes.
TMEA 1P/2.5 / TMEA 1PEx Shaft Alignment Tools 17