Alignment Report; Alignment Report Form - SKF TMEA 1P/2.5 Instrucciones De Uso

4.

ALIGNMENT REPORT

The chapter 4.1 applies to TMEA 1P/2.5 only.
4.1

Alignment report form

In order to facilitate recording of the alignment operation, the TMEA 1P/2.5
is provided with a set of alignment reports.
The report contains the following data fields:
a) Name of the equipment
b) Name of the operator
c) Date
d) Name and/or reference of Stationary machine
e) Name and/or reference of Movable machine
f) Maximum rotational speed
g) Maximum acceptable angle between centre lines of the shafts
h) Maximum acceptable off-set of centre lines
i) Selection of metric or imperial dimensions
j) Machine configuration; distances A, B and C
k) Soft foot correction done
l) Vertical alignment: resulting angular error
m) Vertical alignment: resulting parallel offset
n) Horizontal alignment: resulting angular error
o) Horizontal alignment: resulting parallel offset
p) Vertical alignment: resulting height position of the front feet
q) Vertical alignment: resulting height position of the rear feet
r) Height of shims to be added or removed under front feet
(excluding soft foot correction)
s) Height of shims to be added or removed under rear feet
(excluding soft foot correction)
t) Horizontal alignment: resulting sideways position of the front feet
u) Horizontal alignment: resulting sideways position of rear feet
v) Remaining vertical angle
w) Remaining vertical off-set
x) Remaining horizontal angle
y) Remaining horizontal off-set
z) Space for own notes
32 Shaft Alignment Tools TMEA 1P/2.5 / TMEA 1PEx