Aiming The Laser Beams - SKF TMEA 1P/2.5 Instrucciones De Uso

a) Measure the A, B
and C distances.
b) Adjust each value by using
the + and - buttons.
c) Confirm the setting of each
value by pressing the "next"
button.
Note!
If you need to go back and change values already entered use
the "previous" button.
3.6

Aiming the laser beams

a) Put the two measuring units in the 12 o'clock position with the help
of the spirit levels (fig. 12).
b) Close the targets in front of the positioning detectors (fig. 13).
Fig. 12. The 12 o'clock position
A Stationary M2
B Movable M1
C Movable machine
20
Fig. 11. Machine dimensions
Fig. 13. Close the targets
Shaft Alignment Tools TMEA 1P/2.5 / TMEA 1PEx