Switch On; Machine Dimensions - SKF TMEA 1P/2.5 Instrucciones De Uso

Fig. 9. Cable strap
b) Restrain the force on the cable connection by using the cable strap
(fig. 9).
c) Connect the measuring units to the display unit. Assure that the
marking on the cables corresponds to the marking of the port in the
display unit (fig. 10).
3.4

Switch on

Switch on the display unit by pressing the ON/OFF button. You will now
be prompted to enter the machine dimensions as per chapter 3.5. If no
button is pressed within 60 minutes, the unit will turn off automatically.
3.5

Machine dimensions

The configuration of the machinery is defined by three dimensions.
A: The distance between the two measuring units (as measured
between the centre marks).
B: The distance between the M-marked measuring unit and the front
pair of feet of the Movable machine.
C: The distance between the two pairs of feet of the Movable machine.
TMEA 1P/2.5 / TMEA 1PEx
Fig. 10. Connection of the
measuring units
Shaft Alignment Tools 19