SKF TMEA 1P/2.5 Instrucciones De Uso página 26

a) Confirm this position.
The Movable machine is now
viewed from above hence the
appearance of all four feet on the
display (fig. 25 and 26).
Coupling values
The left value on the display
shows the angle of the centre
lines of the two shafts in the
horizontal plane.
The right value on the display
shows the parallel off-set of the
two centre lines in the horizontal
plane. These two values are the
coupling values in the horizontal
plane.
Machine misalignment should be
within the manufacturer's
specified tolerances. In case
such tolerances are missing,
table 1 can again be used as a
general recommendation.
a) If the measured coupling
values are within the
tolerances, no sideways
adjustment is necessary.
However we still recommend
that you verify the alignment
once more as per chapter 3.9.
b) If the measured coupling values are higher than the acceptable
tolerances we need the feet values.
Press the button to reach the feet values.
26
Fig. 25. Horizontal alignment
Fig. 26. Measured horizontal
misalignment
Coupling values
Shaft Alignment Tools TMEA 1P/2.5 / TMEA 1PEx