Charging The Battery Using The Charger Plug; Before Connecting; Replacing Headlamp Bulbs - Viking MT 5097 Manual De Instrucciones

● Remove the battery. (
Open cover (1) by lightly pressing tabs (2)
to the rear.
Visually check whether fuse (3) is
damaged (blown). If necessary have
fuse (3) replaced by a specialist dealer.
VIKING recommends VIKING specialist
dealers.
● Close the cover again.
● Install the battery. ( 15.19)
56
15.19)
15.21 Charging the battery using the
charger plug
The VIKING ACB 010 battery float charger
or the VIKING ADL 012 diagnostic charger
(both not included in standard equipment)
can be connected to the charger plug.
Only float charging can be performed with
the VIKING ACB 010 battery float charger.
Both float charging and full charging
(charging an empty battery) can be
performed with the ADL 012 diagnostic
charger.
Avoid damage to the machine.
Never charge the battery when the
engine is running.
Only the VIKING ACB 010 battery
float charger or the VIKING
ADL 012 diagnostic charger may
be connected to the charger plug.
Other chargers, particularly those
with a higher charging current, can
damage the machine.
In order to charge the battery using
another chargers, it must first be
removed.

Before connecting:

● Read and observe the information in
the instructions for the VIKING
chargers.
● Read and observe the instructions in
the battery supplementary sheet.
Connecting:
● Stop the engine. (
● Engage the parking brake. (
● Open the engine hood. (
Only connect the VIKING ACB 010 battery
float charger or the VIKING ADL 012
diagnostic charger to the charger plug (1).

15.22 Replacing headlamp bulbs

Bulb designation:
12V 6W BA9s
● Open the engine hood. (
13.3)
8.14)
15.3)
When replacing defective lamp
bulbs, always use 12V bulbs rated
at 6W.
15.3).
0478 192 9807 C - EN