Viking MT 5097 Manual De Instrucciones página 44

Guide retaining pins (1) into the bores in
mounting (2). Insert cotter pin (3) into the
retaining pin bores from above and allow
to engage.
● Repeat this procedure on the other
side.
Tensioning the V-belt (MT 5097,
MT 5097 C, MT 5097 Z):
Pull tension spring (1) forwards and attach
to the mowing deck as shown.
42
Tensioning the V-belt (MT 5112 Z,
MT 6112 C, MT 6112 ZL, MT 6127 ZL):
Press V-belt tensioner lever (1) forwards
and hold in place. Detach retainer (2).
Tension the V-belt by relieving the load on
V-belt tensioner lever (1). Attach
retainer (2) to V-belt tensioner lever (1) as
shown.
Installing the V-belt cover:
Press the retaining plate (1) forwards and
hold in place. Fold the V-belt cover (2)
upwards. Guide the retaining plate (1) to
the rear and engage at the two retaining
tabs (3) on the V-belt cover.
Fasten the retaining plate in place using
the screw (1).
● Install the discharge chute. (
0478 192 9807 C - EN
15.6)