Operating The Machine; Filling The Fuel Tank - Viking MT 5097 Manual De Instrucciones

To start the engine, the following
conditions must always be fulfilled:
– The discharge chute must be correctly
installed.
– The brake pedal must be pressed or the
parking brake engaged.
The engine is switched off if the user:
– Leaves the driver's seat with the
mowing deck engaged.
– Lifts the grass catcher box or removes
the deflector (special accessory) with
the mowing deck engaged.
– Removes the discharge chute with the
mowing deck disengaged.
– Leaves the driver's seat without
engaging the parking brake.
Integrated blade run-down brake:
MT 5097, MT 5097 C, MT 5097 Z,
MT 5112 Z, MT 6112 C, MT 6112 ZL:
Following disengagement, the mowing
blades come to a standstill after 5
seconds at the latest.
MT 6127 ZL:
Following disengagement, the mowing
blades come to a standstill after 7
seconds at the latest.
Following engagement of the
mowing deck, the mowing blades
turn and a wind noise is audible.
The run-on time corresponds to the
duration of the wind noise following
disengagement. This can be
measured using a stopwatch.
32

13. Operating the machine

Risk of injury!
Carefully read and observe the
entire section "For your safety"
before operating the machine.
( 4.)
For safety reasons, the machine
must not be used on slopes with an
inclination of more than 10°
(17.6%).
A slope inclination of 17.6%
corresponds to a vertical height
increase of 17.6 cm for a 100 cm
horizontal distance.
● Familiarise yourself with the controls on
the machine before using it. (
● Before operating the machine, inspect
the maintenance schedule and carry
out all relevant maintenance
operations. ( 15.1)
● Check the safety devices before each
use. ( 12.)
The ride-on mower must not be
operated if safety devices are missing
or damaged or have been bypassed or
modified.

13.1 Filling the fuel tank

Maximum tank capacity:
9 litres
Recommendation:
Fresh good quality fuel, please
refer to the engine instruction manual for
information on fuel grade (octane rating).
– Unleaded petrol.
Filling procedure:
● Stop the engine and allow it to cool
down (warm to the touch). (
● Engage the parking brake. (
To prevent fuel spillage, use a
suitable funnel (not included in
standard equipment) when filling
up.
Pour in the fuel slowly and carefully. In
order to prevent the fuel from overflowing,
filling should be performed in several
stages.
Remove the funnel between the individual
filling operations in order to visually check
the filling level in the tank.
The more fuel has already been filled into
the tank, the smaller the filling quantities
8.)
should be for each filling operation. To give
the fuel room to expand, never fill the fuel
tank past the lower edge of the filler neck.
Tank cap:
Unscrew the tank cap (1) (note direction of
arrow) and remove.
● Fill the fuel into the tank using a suitable
funnel (not included in standard
equipment) (see Filling procedure).
13.3)
8.14)
0478 192 9807 C - EN