Viking MT 5097 Manual De Instrucciones página 43

Attaching the mowing deck at the front
(MT 5097, MT 5097 C, MT 5097 Z):
Pull the front mowing deck mounting (1)
downwards and hold. Raise the mowing
deck slightly with one hand and insert the
mounting pin on the mowing deck into the
bore on the front mowing deck
mounting (1). Insert the cotter pin (2)
through the bore in the mounting pin.
● Repeat this procedure on the other
side.
Attaching the mowing deck at the front
(MT 5112 Z, MT 6112 C, MT 6112 ZL,
MT 6127 ZL):
0478 192 9807 C - EN
Swivel the front mowing deck mounting (1)
downwards and attach to the mowing
deck (2) as shown. Push the mowing
deck (2) slightly to the rear, attaching the
front mowing deck mounting (1) to the
mowing deck.
Fitting the V-belt onto the tension roller
MT 5112 Z, MT 6112 C, MT 6112 ZL,
MT 6127 ZL:
Press cover (1) downwards and hold it.
Push locking pin (2) approx. 0,5 cm
upwards. Fit V-belt (3) onto tension
roller (4).
Push locking pin (1) down again as far as
it will go. Locking pin (1) must engage in
cover (2).
Check that the locking pin is seated
securely.
MT 5097, MT 5097 C, MT 5097 Z,
MT 5112 Z, MT 6112 C, MT 6112 ZL,
MT 6127 ZL:
Press retaining plate (1) forwards and hold
in place. Pull V-belt (2) forwards and lift
with the V-belt cover.
Fit V-belt (2) correctly onto the V-belt
pulley (without twisting).
Attaching the mowing deck at the rear:
Before attaching, check that the
mowing deck is correctly attached
at the front mowing deck mounting.
● Raise the mowing deck with one hand
and hold. The bores in the mounting
must be aligned with the retaining pins
on the mowing deck.
41