Minimising Wear And Preventing Damage; Manufacturer's Declaration Of Ce Conformity - Viking MT 5097 Manual De Instrucciones

Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products.
VIKING recommends VIKING specialist
dealers.
20. Minimising wear and
preventing damage
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blades
– Grass catcher box
– V-belt
– Toothed belt
– Plug-in fuses
– Battery
– Tyres, rollers
– Spark plug
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Improper use of the product.
0478 192 9807 C - EN
– Use of fuel and lubricants not approved
by VIKING (lubricants, petrol and
engine oil, see engine manufacturer's
specifications)
– Product modifications not approved by
VIKING.
– Use of tools or accessories which are
not approved or suitable for the
machine, or are of inferior quality.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Corrosive and other resultant damage
caused by incorrect storage.
– Damage to the machine through the
use of inferior-quality spare parts.
– Damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.
21. Manufacturer's
declaration of CE conformity
We,
VIKING GmbH
Hans Peter Stihl-Strasse 5
A-6336 Langkampfen/Kufstein
declare under our sole responsibility that
the machine
Lawn mower with driver's seat and
combustion engine (MT),
manufacturer's VIKING
brand:
type: MT 5097.1
MT 5097.1 C
MT 5097.1 Z
MT 5112.1 Z
serial number 6160
manufacturer's VIKING
brand:
type: MT 6112.1 C
MT 6112.1 ZL
MT 6127.1 ZL
serial number 6170
conforms to the following EC directives:
97/68/EC, 2000/14/EC, 2014/30/EU,
2006/42/EC, 2006/66/EC
The product has been developed in
conformance with the following standards:
EN ISO 5395-1, EN ISO 5395-3
59