Pico ® Wireless Control Setup; Qs With Dali; Qs Wireless Control Unit - Lutron GRAFIK Eye QS Guía De Instalación Rápida

Pico Wireless Control Setup
®
Associating the Pico wireless control with a GRAFIK Eye
®
(for wireless enabled GRAFIK Eye
1. Make sure the wireless mode of the GRAFIK Eye
Pico
"Enabled".
Change type?
2. On the Pico
buttons for 3 seconds. The info screen on the GRAFIK Eye
Press OK
will display the Pico
control unit to select the desired operation type for the Pico
3a. To assign the Pico
Change type?
buttons to select "Zone" and press the OK button to accept. Use the zone
raise/lower buttons for a zone to select a desired preset level, and then
Zone
press the zone raise and lower buttons simultaneously for 1 second (until the
zone LEDs flash at the programmed preset level). Repeat for all zones you
wish to control with the Pico
OR
OR
Change type?
3b. To assign the Pico
Scene
buttons to select "Scene" and press the OK button to accept. Press and
hold the top scene button on the GRAFIK Eye
(until the scene LEDs flash).
4. On the Pico
3 seconds until the LEDs on the GRAFIK Eye
Saved
Saved
Note: The wireless signal has a range of 9 m through standard construction
®
QS control units only)
®
1 9
wireless control, press and hold the top (on) and bottom (off)
®
options. Press the OK button on the GRAFIK Eye
®
wireless control as a zone controller, use the Master
®
wireless control.
®
wireless control as a scene controller, use the Master
®
wireless control, press and hold the top and bottom buttons for
®
or 18 m line of sight.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye

QS Wireless control unit:

®
2 10 3 11 4 12 5 13 6 14
QS control unit is
®
®
QS control unit for 3 seconds
®
QS control unit stop flashing.
®
QS with DALI Control Unit Quick Installation and Operation Guide 20
®
7 15 8 16
9-16
1-8
OK
QS control unit
QS
®
.
®
1 9
Pico
®
Wireless
Control
Master
buttons
OK
button
Press and
hold the
top scene
button for
3 seconds
to assign
Pico as
®
a scene
controller.
Zone LEDs
2 10 3 11 4 12 5 13 6 14
Zone Raise
Zone Lower
Top/On
button
Bottom/Off
button