Cleaning And Maintenance; Exterior Surfaces - Franke FMY 98 P XS Manual De Usuario

CLEANING AND MAINTENANCE

Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.

EXTERIOR SURFACES

• Clean the surfaces with a damp microfibre cloth�
If they are very dirty, add a few drops of pH-neutral
detergent� Finish off with a dry cloth�
• Do not use corrosive or abrasive detergents� If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth�
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues� To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge�
CLEANING THE COOKING COMPARTMENT WITH THE PYRO CYCLE
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
This function enables you to eliminate cooking
spatters using a high temperature food residues turn
into deposits that can be easily wiped away with a
damp sponge once the oven has cooled down�
If the oven is installed below a hob, make sure that
all the burners or electric hotplates are switched off
while running the self-cleaning cycle�
Remove all accessories from the oven before
running the Pyro function (including the shelf
guides).
For optimum cleaning results, remove excessive
residuals inside the cavity and clean the inner door
glass before using the pyrolytic function�
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
• Clean the glass in the door with a suitable liquid
detergent�
• The oven door can be removed to facilitate cleaning �
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot� Food residues can be removed using a
washing-up brush or a sponge�
during and after (until the room has finished airing)
running the Pyro cycle.
Then oven has two different pyrolytic cleaning
functions: the complete cycle provides for a thorough
cleaning if the oven is extremely dirty, while the quick
cycle (ECO) is shorter and consumes less energy, thus
making it suitable for use at regular intervals�
Only run the Pyro function if the appliance contains
heavy soiling or gives off bad odours during cooking�
Please note: The oven door cannot be opened while
pyrolytic cleaning is in progress. It will remain locked until the
temperature has returned to an acceptable level.
Ventilate the room during and after the pyrolytic
cleaning cycle (until the room has been completely
aerated)�
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
EN
13