Function Settings - Gree EVO Serie Manual De Instrucciones

Unit Control
[Notes]
Move the cursor to the desired option and "Enter" will be displayed at the lower left side of the LCD,
①
reminding you that you are allowed to access to the submenu by pressing the OK key
At the FUNCTION page, when the setting of some function option is changed and needs to be
②
memorized, then in case of power failure it will be saved automatically and resume upon power recovery.
No� Full Name
Running mode
1
setting
2 Control state
Water out
3
temperature control
4 Quiet mode
5 Quiet timer
Weather-
6
dependent mode
7 Holiday release
8 Weekly timer
9 Clock timer
10 Temperature timer
11 Floor debug
12 Emergency mode
13 Holiday mode
14 Thermostat
15 Assistant heater
16 Other heater
17 Chassis heater
Plate heat
18
exchanger heater
19 Floor config
20 Radiator config
21 FCU
22 Remote sensor
23 Air removal
24 Address
25 Gate-controller

Function Settings

Displayed Name
Mode
Ctrl. state T-water out /T-room
High temp./Normal
T-water ctrl
Quiet mode
Quiet timer
Weatherdepend
Holiday release
Weekly timer
Clock timer
Temp. timer
Floor debug
Emergen. mode
Holiday mode
Thermostat With/Without
Assis. heater Off /one/two
Other heater With/Without
Chassis heater
Plate heater
Floor config With/Without
Radia config With/Without
FCU With/Without
Remote sensor With/Without
Air removal
Address
Gate-Ctrl.
Range Default
Cool/Heat Heat
T-water
out
Normal
temp. temp.
On/Off Off
On/Off Off
On/Off Off
On/Off Off
On/Off Off
On/Off Off
On/Off Off
On/Off Off
On/Off Off
On/Off Off
Without
Off
Without
On/Off On
On/Off On
Without
Without
Without
Without
On/Off Off
[1-125]
1
[127-253]
On/Off Off
10
.
Remarks
/
"T-Room" is available only when
"Remote Sensor" is set to "WITH".
If "Floor config" is set to "With", the
control is defaulted to be "Normal
temp.". If not, then the control is
defaulted to be "High temp.".
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
If "Floor config" is set to "With", the
control is defaulted to be "Normal
temp.". If not, then the control is
defaulted to be "High temp.".
/
If "FCU" is set to "With", the range
of water out temperature for cooling
(WOT-Cool) is 7-25 °C,and the default
is 7°C. If not, then the range of the
water out temperature for cooling
(WOT-Cool) is 18-25°C,and the default
is 18°C.
When it is set to "Without", the "Control
state" will be automatically changed to
"T-water out".
/
/
/