Gree EVO Serie Manual De Instrucciones página 23

Go to the FUNCTION page and locate "Air removal", then, configure it through the Up/Down key
, "On" or "Off".
[Notes]
It will not be memorized upon power failure.
①
It can be set only when the unit is turned off.
②
3�3�2�24 Address
It is used to identify the unit in use in the central control system.
[Operation Instructions]
Go to the FUNCTION page and locate "Address", then, configure it through the Up/Down key
set the address.
[Notes]
It indicates the address of the control and is intended for the group control.
①
It will not be memorized upon power failure.
②
The address range is [1,125] and [127,253]
③
The default address is 1 for the initial use.
④
3�3�2�25 Gate-Controller
It can be configured to be "On" or "Off" based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate "Gate-Controller", then, configure it through the Up/Down key
, "On" or "Off".
[Notes]
When it is activated, the control will check the card is inserted or not. If inserted, the control will run
①
normally; if not, the control will turn off the unit and back to the homepage. In this case, any key operation
is ineffective (except for the combined key operation), or a dialogue box will pop up, warning"Keycard
uninserted!".
It will not be memorized upon power failure.
②
3�3�3 Parameter Setting (Parameter Set)
3�3�3�1 User Parameter Setting
At the parameter setting pages, each parameter is configurable, like: water out temperature for cooling,
water out temperature for heating etc.
[Operation Instructions]
1. At the homepage, it is able to go to the PARAMETER page by pressing the Function key no.2
2. At the Parameter Set page, by the Left/Right key
Down key increase or decrease the setting value which will be continuously changed when pressing
and holding the key.
3. When the setting is finished, press "Save"
settings?". If so, press the OK key
and a dialog box will pop up, reminding "Save
; if not press the Cancel key
21
select the desired option and then by the Up/
to not save this setting.
Unit Control
to
.