Gree EVO Serie Manual De Instrucciones página 29

36
37
38
39
40
41 Sensing circuit error or current sensor error
42
43
44
45 Radiator or IPM or PFC module overtemperature
46 Radiator or IPM or PFC module temperature sensor error
47
48
49 Drive board temperature sensor error
50 AC contactor protection or input zero crossing error
51
Current sensor connection protection (current sensor not
52
53 Communication error to the outdoor unit
54 Communication error to the indoor unit
55
3�3�4�4 Version View (VERSION)
At the version view page, the user enables to see the version of the program and the protocol.
[Operation Instructions]
1. At the VIEW page, select Version and then press the OK key
2. At the VERSION page, the program and protocol versions are listed.
16:15
3�3�5 General Setting
At the general setting pages, the user enables to configure general parameters, like temperature unit,
language, On/off memory, time & date etc.
[Operation Instructions]
At the homepage, by pressing "GEN."
set "Temp� unit", "Language", "On/off memory", "Time & Date", "Beeper" and "Back light", as shown in the
figure below.
Start failure
Phase loss
Drive module resetting
Compressor over-current
Overspeed
desynchronizing
Compressor stalling
Communication error
Charging circuit error
Incorrect AC voltage input
Temperature drift protection
connected to phase U/V)
Communication error to the drive
2013-01-04
Program
V 10
Friday
Protocol
V 10
access to the GENERAL SET page. At this page, it is able to
27
Unit Control
Start failure
Phase loss
Driver reset
Com. over-cur.
Overspeed
Current sen.
Desynchronize
Comp. stalling
drive-main com.
Overtemp.-mod.
T-mod. sensor
Charge circuit
AC voltage
Temp-driver
AC contactor
Temp. drift
Sensor con.
ODU Com.
IDU Com.
Driver Com.
to go to the VERSION page.
VERSION
Lc
LD
P6
P0
P5
LF
Pc
H7
LE
P8
P7
Pu
PP
PF
P9
PE
PD
E6
E6
E6