Gree EVO Serie Manual De Instrucciones página 18

Unit Control
the hour or minute values, and by pressing the Up/Down key
value which will be continuously changed by pressing and holding the key. (Unless otherwise specified, all timer
settings follow the similar way.)
4. When the setting is finished, save it by pressing the Function key no. 2
saved is ineffective.
5. When the setting has been saved, activate the "Clock Timer" at the FUNCTION page.
[Notes]
If any one of "Emergen� mode", "Floor debug" and "Thermostat" is set to "on" or "with", "Weekly
①
timer" cannot be turned on.
When "Weekly timer" and "Clock timer" settings are performed at the same time, the latter takes
②
precedence.
3�3�2�10 Temp� Timer
This function will make the unit run with certain temperature in a certain period within a day based on the
user's actual needs.
[Operation Instructions]
1. At the homepage, by pressing the Function key
where "Temp� timer" is, after that, press OK key
16:15
2 At the TEMP TIMER setting page, by the Left/Right key
by the Up/Down key
1", "Period 2" and "WT-HEAT 2".
3. When the setting is finished, save it by pressing the Function key no. 2
saved is ineffective.
4. When the setting has been saved, activate the "Temp� timer" at the FUNCTION page.
[Notes]
If any one of "Emergen� mode", "Floor debug" and "Thermostat" is set to "on" or "with", "Weekly
①
timer" cannot be turned on.
When "Weekly timer", "Clock timer", and "Temp� timer" settings are performed at the same time, the
②
"Temp� timer" takes precedence.
This function works only when the unit is in operation.
③
The allowed running modes include "Heat" and "Cool".
④
When the start time of "Period 2" is equal to that of "Period 1", then the set point of "Period 2" takes
⑤
precedence.
2013-01-04 Friday
Mode
Heat
Period 2 WT-heat 2
17:30
Save
configure it. The configurable parameters include "Mode", "Period 1", "WT-HEAT
increase or decrease the corresponding
access to the FUNCTION page, and then locate
to go to the TEMP TIMER setting page.
TEMP TIMER
Period 1 WT-heat 1
08:30
35℃
select the desired parameter and then
16
, or this setting without being
35℃
, or this setting without being