Gree EVO Serie Manual De Instrucciones página 26

Unit Control
2. At the STATUS page, it is able to check the status of each component.
16:15
Compressor
HP-pump
Full Name
Compressor running state
Fan 1 running state
Fan 2 running state
Heat pump-water pump
Swimming pool-water pump
3-Way valve 1 running state
Crankcase heater running state
Chassis heater running state
Plate heat exchanger heater
Defrost
Oil return
Thermostat
Assistant heater running state
Circulating two-way valve 1 running state
Circulating two-way valve 2 running state
Gate-controller
Opration LED
Error LED
4-way valve running state
Enthalpy-enhancing solenoid valve
Heat pump-auxiliary heater 1
Heat pump-auxiliary heater 2
Heat pump-freeze protection
3�3�4�2 Parameter View (Para View)
At the parameter view pages, the user enables to view the units' running parameters, like outdoor
temperature, suction temperature, discharge temperature, water in temperature, water out temperature etc.
[Operation Instructions]
1. At the VIEW page, select Parameter and then press the OK key
2. At the Para View page, it is able to view each parameter.
2013-01-04 Friday
Off
Swimming-pump 3-way valve 1
Off
Viewable Components
Displayed Name
Compressor
Swimming-pump
3-way valve 1
Crankc.heater
Chassis heater
Plate heater
Thermostat
Assist. Heater
2-way valve 1
2-way valve 2
Opration LED
4-way valve
HP-heater 1
HP-heater 2
HP-Antifreeze
Fan 1
Off
Off
Last
Fan 1
Fan 2
HP-pump
Defrost
Oil return
Gate-Ctrl.
Error LED
En.valve
24
STATUS
Fan 2
Off
Off
Next
Status
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
Off/Cool/Heat
On/Off
On/Off
On/Off
Card in/Card out
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
to go to the Para View page.