Safety - Vogel IG502-E Instrucciones Para El Manejo

1. Safety

The components are designed and manufactured
in conformity with the generally accepted engineer-
ing standards as well as applicable industrial safety
and accident prevention regulations. Though con-
structed to meet all relevant safety requirements,
their use may still entail dangers leading to personal
injury of the user or third parties or damage to
property. Therefore, the components shall only be
used when they are in a technically perfect condi-
tion, the operating instructions having to be duly
observed. Any faults, in particular faults which may
affect safety, shall be rectified without delay.
Texts marked with this symbol contain
information on special dangers or
important operations and works.
Use in conformity with intended purpose
The unit described herein is designed exclusively
for controlling and monitoring Vogel centralized
lubrication systems.
Therefore, it may be used exclusively for the
purpose specified in this manual. The user himself
shall be liable for any improper use and the damage
resulting therefrom.
Danger caused by electrical current
The units may be connected to the power supply
exclusively by appropriately trained qualified per-
sonnel in conformity with the local connection
conditions and regulations (e.g. DIN, VDE)! Impro-
perly connected equipment may lead to serious
personal injury and damage to property!
The control unit is designed for use in battery-
powered on-board electrical systems of vehicles
and construction machines. When used for any
other purposes, all applicable safety regulations
shall be complied with.
Approved personnel
The components described in this manual may be
installed, operated, maintained and repaired only
by qualified personnel.
Qualified personnel means persons trained, as-
signed and instructed by the operator of the equip-
ment concerned. These persons are familiar with
the applicable norms, rules, accident prevention
regulations and operating conditions on account
of their training, experience and the instructions
received. They are entitled to carry out the activities
required in a given case and will be able to recog-
nize and avoid possibly existing dangers.
DIN VDE 0105 or IEC 364 contains the definitions
for specialists and the prohibition to use unqualified
personnel.
Page 2
Contents Chapter
1
Lubrication
Operating Instruction Universal Control Unit IG502-E
Central