Programming; Starting The Programming Mode - Vogel IG502-E Instrucciones Para El Manejo

7. Programming

•
Programming always starts with steps 1 to 2!
•
Flashing of the displays indicates that
programming mode is active.
7.1

Starting the programming mode

7.2 Changing the pause or pump running
times
Carry out steps 1 to 2!
Step Key
1
Press for more than 2s
2
Press briefly
(to confirm code)
3
Press briefly
4
5
Press briefly
(to confirm new value)
6
Press briefly
7
Page 21
Operating Instruction Universal Control Unit IG502-E
Display
Display flashes
(code 000 factory setting)
Pause time in timer mode
LED „Pause" flashes
Pause time 9 h (factory setting)
Set new value
Example: 6.8 h
Pump running time in timer mode
LED „Contact" flashes
Pump running time 2.6 min
(factory setting)
Set new value
Example: 3 min
Next Chapter
Central
7
Lubrication