Changing The System Monitoring Settings - Vogel IG502-E Instrucciones Para El Manejo

7.3 Changing the system monitoring
settings
Carry out steps 1 to 2!
Step Key
8
Press briefly
9
Press for more than 2s
Step Key
3
Press until:
4
Press briefly
5
Operate appropriate
key until
6
Press briefly
7
Press for more than 2s
Page 22
Contents
Operating Instruction Universal Control Unit IG502-E
Display
To confirm new value
New settings are saved to the memory and the
display goes out.
Display
Beginning of monitoring settings
is displayed
Monitoring via pressure switch
(factory setting)
LED „CS" flashes, or
monitoring via cycle system monitoring OFF is displayed
switch is set
To confirm new setting
New settings are saved to the memory, and the
display goes out.
Chapter
Central
7
Lubrication