Vogel IG502-E Instrucciones Para El Manejo página 51

Replacing IG434-1
Abbreviated programming instructions
•
For changing over the programming of
IG502-E to the operating mode of the IG434-1,
the factory settings must be changed as follows:
Step Key
1
Press for more than 2s
2
Press briefly
(to confirm code)
3
Press briefly
4
5
Press briefly
(to confirm new value)
6
Press briefly
7
Page 8
Operating Instruction Universal Control Unit IG502-E
Display
Display flashes
(code 000 factory setting)
Pause time in timer mode
LED „Pause" flashes
Pause time 9 h
(factory setting)
Set new value
Pump running time in timer mode
LED „Contact" flashes
Pump running time 2.6 min
(factory setting)
Set new value
Next Chapter
Central
2.2
Lubrication