Auto/Manual/Off - Generac 20 kW Synergy Guia De Instalacion

Operation
*
With the control pad set to AUTO, the engine may crank and start at any time without warning.
Such automatic starting occurs during the programmed exercise cycle or when utility power
source voltage drops below the configured level. To prevent possible injury that might occur
during sudden starts, always set the control pad to OFF and remove the 7.5 amp fuse before
working on or around the generator or transfer switch. For added security, place a DO NOT
OPERATE tag or placard at both the control pad and transfer switch.
NOTE: Never run the generator with any access panel removed.
LCD Screen
7.2 — Auto/Manual/Off
Feature
Press to activate fully automatic operation. Green LED illuminates to confirm that system is in AUTO mode.
AUTO Transfer to standby power occurs if utility power fails.
Functionality of exercise timer is enabled, if set.
Press to crank and start engine. Blue LED illuminates to confirm that system is in MANUAL mode.
MANUAL Transfer to standby power occurs if utility power fails.
Functionality of exercise timer is disabled.
Press to shut down engine, if running. Red LED illuminates to confirm that system is in OFF mode.
OFF
Transfer to standby power does not occur if utility power fails.
32
Green
LED
AUTO
MANUAL
OFF
Figure 7-2. Control Pad and LCD Screen
UP ARROW
Blue Red
LED LED
ESCAPE
Description
Installation Guidelines for Air-Cooled Generators
ENTER
DOWN ARROW