Dismantling And Disposal - HPP H Serie Instrucciones Para El Ensamblaje -Uso Y Mantenimiento

m
WARNING!
• All cleaning jobs must only be performed after carrying out the operations described in the "STOP"
paragraph, meaning without any moving parts, no pipe full of liquid under pressure and only after
complete cooling.
In particular, always remember to disconnect the power supply.
• Any cleaning jobs must be performed in conditions of total stability.
• To clean, do not use thinners or solvents.
CAUTION!
• The pump must be protected against freezing.
In very cold environments, to prevent the ice from forming inside, after use, always empty out all the
pumped liquid.
In case of ice, do not operate the pump.
Failure to abide by these instructions can cause serious damage to the pump.
• During storage, protect the pump from dirt and dust.
• In case the pump is not required to operate for over two months, the pump must be completely filled
with oil.
After a long time without operating (over six months), contact a Skilled Technician to:
- change the pump oil;
- inspect the suction/delivery valves;
- check the efficiency of the seals.
Only qualified persons must be allowed to dismantle the pump and this operation must be performed in
compliance with the laws applicable in the country where the machine in which it is integrated has been
installed.
The product is covered by a 3 (three) year warranty from the date of delivery, as long as the buyer has
complied with contractual norms.
With regard to warranty acceptance procedures, refer to the general sales conditions.
CLEANING AND DECOMMISSIONING

DISMANTLING AND DISPOSAL

WARRANTY
47
IT
EN
FR
ES
DE
PB