Memorization Mode I; Memorization Mode; Remote" Memorization - Nice Spin Instrucciones Y Advertencias Para El Instalador

4.6.2) Memorization mode I

Table 11: to memorize a transmitter in mode I
1. Press the key on the receiver and hold it down (approx. 3s)
2. Release the key when the LED on the receiver lights up
3. Within 10s, press any key on the radio transmitter to be memorized and hold it down for at least 2s
4. If the memorization procedure is successful, the LED on the receiver will flash 3 times.
If there are other transmitters to be memorized, repeat step 3 within the next 10 s, otherwise the memorization stage will terminate
automatically.
4.6.3) Memorization mode II
Table 12: to memorize the key of a transmitter in mode II
1. Press the key on the receiver as many times as the number corresponding to the desired command,
according to table 8
2. Make sure that the LED on the receiver makes as many flashes as the number corresponding
to the selected command
3. Within 10 s, press any key on the radio transmitter to be memorized and hold it down for at least 2 s
4. The LED on the receiver will flash 3 times if the memorization procedure has been successful.
If there are other transmitters to be memorized for the same type of command, repeat step 3 within the next 10 s, otherwise the
memorization stage will terminate automatically.

4.6.4 "Remote" memorization

A new radio transmitter can be memorized without directly operating
the keys on the receiver. You need to have a pre-memorized opera-
tional radio transmitter The "new" radio transmitter will inherit the
characteristics of the old one, i.e. if the old radio transmitter was
memorized in Mode 1, the new one will also be memorized in Mode
1. In this case, during the memorization stage you can press any key
on the two transmitters. If, on the other hand, the old transmitter was
memorized in Mode II, the new one will also be memorized in Mode
II: you must press the key on the old transmitter which corresponds
to the desired command, and the key on the new transmitter to
which you wish to associate that command.
Holding the two transmitters, position yourself within the operating range of the automation and perform the following operations:
Table 13: for the "Remote" memorization of a transmitter
1. Press the key on the new radio transmitter and hold it down for at least 5 s, then release it.
2. Press key on the previously memorized transmitter slowly 3 times.
3. Press the key on the new radio transmitter once slowly
At this point the new radio transmitter will be recognized by the receiver and will assume the characteristics of the previously memorized
one. If there are other transmitters to be memorized, repeat all the steps above for each new transmitter.
14
41
!
Remote memorisation can occur in all those receivers
which are within range of the capacity of the transmitter.
Therefore, only the one which is actually involved in the
operation must be powered.
Example
3s
2s
x3
Example
1....4
1....4
2s
x3
Example
5s
1s 1s 1s
1s