Tabla de contenido
Publicidad
Modelo 8450 Manual de Servicio
Components
Mercury-PC Setup
The PC RS232 to Mercury-PC cable
is a DB9 M-to-F straight through
cable. A flat cable, P/N
15138600A is available from
®
METTLER TOLEDO
that will allow
connection to the serial port without
tilting the Mercury-PC adapter.
3-26
(6/00)
Ethernet to
Scale Cable
Mercury-PC Adapter
When installing an RF scale, you will set up the unit's Ethernet parameters, then set up
the Mercury-PC.
Serial Cable to Mercury-PC
You will need a PC and a serial cable to set up the Mercury-PC. The Mercury-PC is
installed behind the printer. For access to the Mercury-PC, remove the printer door, press
down on the release lever, and slide the printer forward. The Mercury-PC is mounted on
the vertical frame behind the printer using a snap on bracket. Turn the power to the scale
off before connecting the cable to the Mercury-PC Adapter. If a flat cable (P/N
15138600A) is not used, the module may need to be tilted outward to plug in the serial
cable.
RS232
Power Supply
Serial Port
Cable
PCMCIA Radio
Mercury-PC Components (Printer cover removed)
Connecting a Serial Cable to Mercury-PC Module
Antenna
Connect serial
cable here.
Publicidad
Tabla de contenido
