Modelo 8450 Manual de Servicio
Ethernet Hub Port on RF
Scales
Note: To connect a single Ethernet
Scale to an Ethernet RF scale, a
crossover patch cable can be used
instead of the hub.
3-30
(6/00)
The RF scales have an active 10BASE-T hub port on the bottom of the scale. You can
use this port to connect the scale as a standard wired Ethernet scale or it can be used to
connect multiple Ethernet scales using one wireless radio on the Symbol® 802.11
network, as shown below. Up to ten nodes can be connected in this manner.
8450
Client
8461
STEM
Int. RF
10BA SE -T
H u b
8461
Client
Symbol® RF Supporting Multiple Wired Ethernet Nodes
RF Access
Point