Transport, Assembly, Putting Into Operation And Decommissioning; Transport; Assembly (Built-In Appliances Only); Unheated Appliances (Ebr/V19-26 | Ebr/V27-33) - Hupfer TE-2/V19-26 Manual De Instrucciones

Ocultar thumbs Ver también para TE-2/V19-26:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 232
Chapter 4
Page 20
4
Transport, Assembly, Putting into Operation and Decommis-
sioning
4.1

Transport

ATTENTION
4.2

Assembly (Built-in appliances only)

ATTENTION
The following section describes the assembly of the built-in plate dispenser.
Primarily, the unheated appliances EBR/V19-26 and EBR/V27-33 are described that do not require any elec-
trical installations after the assembly.
Subsequently, there follows the assembly description of the heated appliances EBRH/V19-26, EBRH/V27-33
and EBRH-2/19-26 that must be connected to the power supply after the assembly.
4.2.1

Unheated appliances (EBR/V19-26 | EBR/V27-33)

NOTE
Figure 4
Plate dispenser
TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26

Transport, Assembly, Putting into Operation and Decommissioning

Appliance damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly. The brakes are not sufficient as a transport se-
curing method.
If the appliances are not secured properly, there is a risk of damage to proper-
ty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Exposed springs
When pressing down the stacking platform manually, the springs are ex-
posed. Reaching into the gaps of the exposed springs may cause hand inju-
ries.
Never press the stacking platform down manually.
Be careful when hooking and unhooking the springs. When adjusting springs
on sharp edges, pay particular attention to the ends of the tension springs.
Appliance location
Built-in appliances may only be used after being retrofitted or built-in (e.g. in a
cabinet).
Worktop cut-out EBR/V19-26
Transport
4330000_A6

Publicidad

Tabla de contenido
loading

Tabla de contenido