Vollrath SLP300A/S Manual De Instrucciones página 10

SAFE BLADE REMOVAL
1. Unplug the slicer from the electrical outlet.
2. Remove the blade guard cover.
3. Clean the front side of the blade. See "Clean the Slicer" on page 8.
4. Remove the sharpener.
5. Rotate the blade so that the screw holes are parallel to the base of
the slicer.
6. Place the safe blade removal tool on the blade and align the two
knobs on the tool with the holes in the blade.
Tip: Rotate the tool so the warning label is at the top of the tool and
the notch fits around the bump out of the blade guard.
7. Tighten the knobs to secure the tool to the blade.
8. Remove the screws that fasten the blade to the slicer.
10
9. Lift the safe blade removal tool to remove the blade.
10.Use a brush to clean any debris from the area where the blade
attaches to the slicer body.
11.Reverse the procedure to reinstall the blade. Verify the blade is
installed flat against the pulley.
12.Plug the slicer into the electrical outlet.
Heavy-Duty Automatic Electric Slicer Operator's Manual