Vollrath SLP300A/S Manual De Instrucciones página 9

CLEAN AND SANITIZE THE SLICER (CONTINUED)
Sanitize the Slicer
NOTICE: The sanitizer concentration shall comply with Section
4-501.114, Manual and Mechanical Warewashing
Equipment, Chemical Sanitization – Temperature, pH,
Concentration, and Hardness of the FDA Food Code.
NOTICE: If a chemical sanitizer other than chlorine, iodine or
quaternary ammonium is used, it shall be applied in
accordance with the EPA registered label use instruction.
1. Wash your hands.
2. Soak the removable parts in a clean basin in a solution of clean
warm water and correctly-diluted sanitizing solution.
3. Remove the parts from the basin and allow them to air dry. Do not
rinse or wipe the sanitizer off of the parts.
4. Moisten a soft clean cloth with correctly diluted sanitizing solution.
5. Use the cloth to sanitize the non-removable parts and body of the
slicer. See Step 3 under "Clean the Slicer." Do not rinse or wipe the
sanitizer off of the parts.
Reassemble the Slicer
1. Install the slice guard.
2. Install the automatic carriage guard.
3. Position the blade cover so the cover knob is at the bottom, as
shown below. Install the blade cover knob and secure the blade
cover.
4. Install the carriage tray and fully tighten the carriage tray release
knob.
NOTICE: Under-tightening the knob could cause the carriage tray
to wobble and result in damage to the gauge plate or
slicer body.
5. Install the product grip handle.
6. Install the blade sharpening assembly.
7. Install the food fence.
8. Lubricate the gauge plate slide with the oil supplied with the slicer or
with a food-grade lubricant.
Heavy-Duty Automatic Electric Slicer Operator's Manual
Inspect the Slicer
• Inspect the slicer for correct assembly.
• Verify the carriage release knob is fully tight and the carriage tray
does not wobble. Gently move the carriage to verify the carriage
release pin is fully retracted and does rub against the slicer body.
• Verify the slicer is in good working condition.
• Do not use the slicer if it is not in good working condition. Contact
authorized Vollrath service agency to service the slicer.
9