LUBRICATION
To ensure smooth and safe operation properly lubricate the slicer.
Carriage Slide
Lubricate the carriage slide monthly or more frequently as needed. See
"Lubricate Carriage Slide" on page 11.
Gauge Plate Slide
Lubricate the gauge plate slide at least daily, and after every cleaning
with the oil supplied with the slicer or a food-grade lubricant.
6
OVERLOAD RESET SWITCH
If the slicer becomes overloaded the reset switches stop the slicer to
protect the motor. In case of overload:
1. Press and release the Power OFF button.
2. Unplug the slicer power cord from the electrical outlet.
3. Remove the food that caused the overload. If necessary, clean the
equipment. See "Clean and Sanitize the Slicer" on page 7.
4. Press and release both reset buttons, located on the bottom of the
slicer.
5. Plug the slicer cord back into the same electrical outlet from which it
was removed.
6. Press and release the Power ON button.
7. If the carriage tray will not operate in automatic mode, press and
release both button, located on the bottom of the slicer. If the
problem persists, contact Vollrath Technical Services.
Reset should be a rare occurrence and should be due to overloading the
slicer. Contact a Vollrath authorized repair service center if the switch is
activating often during normal use.
Heavy-Duty Automatic Electric Slicer Operator's Manual