Product Description And Specifications; Technical Data - Bosch Active Line Serie Manual Original

English–5

Product Description and Specifications

6
5
3
11
6
5
10
4 3
Product Features
All representations of bike components, with the exception
of the battery packs and their holders, are schematic and
can deviate from your eBike.
1 Holder for the rack-type battery pack
2 Rack-type battery pack
3 Operation and charge-control indicator
4 On/Off button
5 Key for the battery pack lock
6 Battery pack lock
0 275 U07 XPX | (14.4.16)
198
1
C7 C6
2
4
7
8
9
13
12
7 Upper holder for the standard battery pack
8 Standard battery pack
9 Bottom holder for the standard battery pack
10 Cover lid (Supplied only on eBikes with 2 battery
packs)
11 Battery charger
12 Socket for charge connector
13 Charge socket cover
Bosch eBike Systems

Technical Data

Lithium-ion battery pack
Article number
– Standard battery pack
– Rack-type battery pack
Rated voltage V=
Rated capacity Ah
Energy Wh
Operating temperature °F
Storage temperature °F
Permitted charging temperature range °F
Weight, appox. lb
Degree of protection
This device is in compliance with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device must not cause harmful interference, and
(2) this device must accept any interference that is received, including interference that may cause undesired operation.
This device is in compliance with CAN ICES-3(B)/NM B-3(B).
Assembly
 Put the battery pack down only on clean surfaces. In
particular, avoid getting the charge socket and the con-
tacts dirty, e.g., with sand or soil.
Checking the Battery Pack Before Using for the
First Time
Check the battery pack before charging it or using it with
your eBike for the first time.
To do this, press the On/Off button 4 to switch on the bat-
tery pack. If no LED for the charge-control indicator 3 lights
up, then the battery pack may be damaged.
When at least one of the LEDs, but not all, for the charge-
control indicator 3 is lit, then fully charge the battery pack
before using it for the first time.
 Do not attempt to charge or use a damaged battery
pack. Please contact an authorized Bosch eBike dealer.
Charging the Battery Pack
 Only use the Bosch charger provided with your eBike
or an identical original Bosch charger. Only this char-
ger is matched to the lithium-ion battery pack used in
your eBike.
Note: The battery pack is supplied partially charged. To en-
sure full battery pack capacity, completely charge the bat-
tery pack in the charger before using it for the first time.
Bosch eBike Systems
PowerPack 400 PowerPack 500
0 275 007 524/538 0 275 007 533/534
0 275 007 525/526 0 275 007 535/536
36
11
400
+23...+104
+14...+140
+32...+104
5.5/5.7
IP 54 (dust and splash water IP 54 (dust and splash water
protected)
To charge the battery pack, read and follow the operating
instructions for the charger.
The battery pack can be recharged at any time on its own or
on the bike without shortening the its service life. Interrupt-
ing the charging process does not damage the battery pack.
The battery pack is equipped with a temperature control in-
dicator, which enables charging only within a temperature
range between 32 °F and 104 °F.
When the battery pack is not within the
charging temperature range, three
LEDs of the charge-control indicator 3
flash. Disconnect the battery pack from
the charger until its temperature has ad-
justed.
 CAUTION: Do not connect the battery pack to the
charger until it has reached the permissible charging
temperature.
0 275 U07 XPX | (14.4.16)
English–6
36
13.4
500
+23...+104
+14...+140
+32...+104
5.7/6.0
protected)
199