Craftsman 27712 Manual De Las Instrucciones página 23

Ocultar thumbs Ver también para 27712:
Tabla de contenido

Publicidad

2
_To
install bagger components
to tractor
1.
Discharge Chute
2. 3/8 Nut
3.
Flat Washer
3
1. SupportBracket
2. 3/8 Carriage Bolt
1
3. 3/8 Lock Nut
4.
3/8 x 63,5mm Hex Bolt
5.
10,3mm
(13/32")
flat
washer
5
Removedischargechutefrom rearoftractor.Unhookthe
two (2) strapsand pullchute out and away fromtractor.
Removethe two (2) 3/8 nutsand flat washersfrom the
boltsat the tractorback plate.
1.
2.
3.
3/8 Lock nut
Flat Washer
Support Tube
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
Install the two upper support brackets through the back
plate and to the chassis, using the 10 x 19 mm (3/8"x3/4")
carriage bolts and Iooknuts supplied. Tighten securely.
Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5rnm hex
bolts13/32" I.D. flat washers and 3/8 Iooknuts from parts
bag. Tighten securely.
1. Hook
2.
Discharge Chute
3.
Back plate slot
3
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate.This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido