Craftsman 27712 Manual De Las Instrucciones página 24

2
1
1. Front bagger tube _,,
2. Lower baggertube
3. 1/4 x 50,8mm Carriage
Bolts
4. 1/4 Lock nut
2
Front bagger tube It,
,JF
2. 1/4_50,8mm Carriage
3. 1/4 Lock nut
4. Vinyl Binding
5. Dump handle tube
6. Clevis pin
7. Retainer spring
1. TopSurfacesEven
2. Horizontal A djustment B racket
3. VerticalAdjustmentBracket
4
6MM
To Assemble Bagger
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
gether,
• Holes in front bagger tube are at an angle. Place front
bagger tube against lower bagger tube and check for
proper hole alignment before assembling bolts.
Assemble front and lower bagger tubes using four (4)
1/4 x 50,8mm carriage bolts and lock nuts supplied.
Tighten securely.
Slide front and lower bagger tube assembly into the bag-
ger assemby.
Assemble front and upper bagger tubes using four (4)
1/4 x 50,8mm carreige belts and lock nuts supplied.
Tighten securely.
• Slip all the vinyl bindings over the bagger tubes
• Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin and secure with retainer
spnng.
NOTE: For future use, the clevis pin may be removed in order
to use the handle to clear the chute in the event it has become
clogged,
Bagger adjustment
For properbag functionand appearance,it may be neces-
sary to adjustthe bagger assembly. T here shouldbe 6mm
( 1/4")-9mm(3/8")gapbetweenthebegger topandfenderand
the baggertop surfaceshouldbe even with the top surface
of the fender. To adjustbaggerposition:
Horizontal adjustment
Slightly loosen the nuts securing the bagger RH and LH
hedzontal adjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
Move the brackets the amount forward or backward you
wish the bag assembly to move. Retighten the nuts se-
curely.
Vertical adjustment
Slightly loosen the nuts secudng the vertical adjustment
brackets. Loosen only enough so the brackets keep their
position, bet allow them to be moved.
Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
Reinstall the bagger assembly and check the bagger to
fender fit. If necessary, repeat the procedure until proper
fit is attained.
To convert to bagging, mulching or discharge
See "Section 5" of this manual.
24