Publicidad
Idiomas disponibles
Idiomas disponibles
3 41 01 169 21 0.book Seite 13 Mittwoch, 7. September 2011 3:32 15
Assembly instructions.
Filling coolant tank.
Before mounting or replacing cutting tools or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Prevent the flow of liquid along the cable into the socket or into the core drill,
WARNING
as this can lead to electric shock. Tie a bow in the cord near the plug so that
any liquid can drip off.
Only use water soluble cutting fluid that is capable of being pumped like Slugger Cutting Fluid.
Filling the mounted coolant tank (Fig. 4).
Pull off the upper closing cap of the
coolant tank.
Fill in pump-feedable water soluble
Slugger Cutting Fluid. Do not use oil!
Mount the upper closing cap firmly
onto the coolant tank.
Fig. 4
Upper closing cap
Coolant container
en
13
Publicidad
