Publicidad
Idiomas disponibles
Idiomas disponibles
3 41 01 169 21 0.book Seite 15 Mittwoch, 7. September 2011 3:32 15
Changing the tool.
Secure the power tool with the safety strap supplied at all times, especially for
WARNING
work carried out at elevated heights, when drilling horizontally or above the head.
If there is a power loss, or the power plug is pulled out, the magnetic holding power is not
maintained.
Before mounting or replacing cutting tools or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Carbide tipped cutter (Fig. 6).
Insert the pilot pin into the carbide tip-
ped cutter.
Pull the QuickIN Max clamping sleeve
of the tool holder downward. Insert the
carbide tipped cutter with the pilot pin.
Do not touch the sharp edges of the carbide tip-
ped cutter.
Key-type drill chuck (Fig. 7).
Turn the QuickIN clamping sleeve of
the tool holder leftward and insert the
geared drill chuck.
Twist drill bit (Fig. 8).
Turn the knurled nut until it spins
through.
Place the drift in position and apply a
hammer blow to remove the tool hol-
der.
Clean the inside cone of the output
shaft and insert the twist drill bit.
Fig. 6
Carbide tip-
ped cutter
Fig. 7
Fig 8
1.
3.
4.
Twist drill bit
en
15
QuickIN Max.
tool holder
Pilot pin
QuickIN
tool holder
Key-type drill
chuck
Drift
2.
Knurled nut
Publicidad
