Publicidad
Idiomas disponibles
Idiomas disponibles
3 41 01 169 21 0.book Seite 16 Mittwoch, 7. September 2011 3:32 15
en
16
Working instructions.
Secure the power tool with the safety strap supplied at all times, especially for
WARNING
work carried out at elevated heights, when drilling horizontally or above the head.
If there is a power loss, or the power plug is pulled out, the magnetic holding power is not
maintained.
For switching the magnet ON (Fig. 9).
Please make sure that the contact surface
for the magnetic base is level, clean and
rust-free. Remove any varnish or primer.
When working, always use the magnetic
base; ensure that the magnetic holding
power is sufficient:
– When the red warning light in the button of
the control panel is not lit and when the
main switch in the drill stand is lit perma-
nently, the magnetic holding power is suffi-
cient and the machine can be operated with
automatic feed.
– When the red warning light in the button of
the control panel and the main switch flash,
the magnetic holding power is insufficient
and the machine must be operated with
manual feed.
When working on materials that are non-fer-
rous, suitable fixation devices obtainable as
accessories from the manufacturer, e. g. suc-
tion plates, vacuum plates or pipe-drilling
devices must be used.
When working on steel materials with a
material thickness of less than 12 mm /
the workpiece must be reinforced with an
additional steel plate in order to guarantee the
magnetic holding power.
The magnetic base is monitored by means of
a power sensor. If the magnetic base is defec-
tive, the motor will not start.
Press the magnet switch to start the
machine.
Magnet switch
=
Safety strap
1
/
in,
2
Fig. 9
Publicidad
