Kit Assembly; Kit Preparation - Metra 95-8202 Instrucciones De Instalación

For the Scion TC (both generations) and XA:
Cut off the front upper section of the double DIN
trim plates, as shown by the dotted lines labeled
"A" in. (Figure A)
For the 2001-2005 Toyota Rav4, 2001-2007 Toyota
Highlander (without factory navigation), 2003-2006
Toyota Tundra and 2003-2007 Toyota Sequoia:
A
A
A
B
B
(Figure A)
Cut off the rear section of the double DIN trim
plates, as shown by the dotted lines labeled "B" in.
(Figure A)
For the 2013-up Scion FR-S and Subaru BRZ:
Cut the double DIN trim plate as shown in.
(Figure B)
Note: Care must be taken to cut this. A Dremel tool
and a steady hand must be used. If the bracket is
A
If bracket is broken
B
B
during trimming use
this portion.
(Figure B)

Kit Assembly 95-8202

Kit Preparation

18
damaged you can still use the it by using the single
screw hole leftover. If you do go this route, you will
have to brace up the rear of the radio to prevent it
from dropping down. (Figure B)
For all other vehicles skip to Step 1.
Carefully cut-out the
shaded area using a dremel
tool to accommodate for the
factory bracket.
Style of factory
brackets may differ.