Connecting Cable Tv - Samsung HL-TS087S Manual De Usuario

Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1 Plug the incoming cable into the ANT 1 IN (CABLE) terminal on the side of the TV.
> Because this TV is cable-ready, you do not need a cable box to view unscrambled cable
channels.
Connecting to a Cable Box that Descrambles All Channels
1 Find the cable that is connected to the ANT OUT terminal on your cable box.
> This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT'
2 Connect the other end of this cabte to the ANT1 IN (CABLE) terminat on the side of the TV
AN=TIN ANT O U_ll_=
Connecting__ a Cable Box that Descrambles Some Channels
If your cable box deecrambtes only some channels (such as premium channels), follow the instructions below. You wilt need
a two-way splitter, an RF (A/B) switch, and four lengths of Antenna cable. (These items are available at most electronics
stores.)
1 Find and disconnect the cable that is connected
to the ANT IN terminal on your cable box.
> This terminal might be labeled "ANT IN"+
"VHF IN" or simply, "IN++
2 Connect this cable to a two-way splitter.
3 Connect anAntenna cable between an OUTPUT
terminal on the splitter and the IN terminal on the
cable box.
4 Connect an Antenna cable between the ANT OUT
terminal on the cable box and the B-IN terminal
on the RF(A/B) switch.
y+
-G
Incoming
cable
Splitter
incoming
cable
Cabte Box
Incoming
cable
Splitter
RF (A/B)
Cable Box Switch
Connect another cable between the other OUT
terminal on the splitter and the A-IN terminal on
the RF (A/B) switch.
Connect the last Antenna cable between the OUT
terminal on the RF (A/B) switch and the ANT 1 IN
(CABLE) terminal on the side of the TV.
P L ) RF (A/B)
Cable Box Switch
cable Splitter _ RF (A/B)
Cable Box Switch
TV Side 1
_%'"
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the 'B' position to
view scrambled channels. (When you set the A/B switch to "B", you will need to tune your TV to the cable box's output channel, which
is usually channel 3 or 4.)