Technical Alarm; Chapter 13 Spo 2 Measurement Function - Gima CONTEC08A Manual De Instrucciones

69 ENGLISH
alarm is ON, the physiological alarm will occur; in ALARM SETUP interface, select SpO ALARM SETUP
2
option to enter its interface, when the SpO measurement result is higher than the high limit or lower than
2
the low limit and the alarm is ON, the physiological alarm will occur.
In the state of physiological alarm, press any button to cancel the alarm and it does not affect the next
alarm; the alarm can be closed permanently with alarm switch of the alarm setup menu until the alarm
switch be opened again.

12.2 Technical Alarm

When power is about to exhaust and alarm is on, the alarm will occur. This alarm can not be cancelled
unless being closed or the power replaced.
Chapter 13
SpO MEASUREMENT FUNCTION
2
(This chapter is only suitable for European Union market)