Chapter 14 Spo 2 Measurement Method - Gima CONTEC08A Manual De Instrucciones

Chapter 14
SpO MEASUREMENT METHOD
2
(This chapter is only suitable for European Union market)
1. Attach the SpO probe to the appropriate site of the patient finger as the following figure.
2
2. Plug the connector of the SpO
The main interface will switch to SpO
which is changeable according to different individual pulse rate. This operation brings no affection to
other functions.
Warning
Uncomfortable or painful feeling may appear if using the device ceaselessly, especially, for the
microcirculation barrier patients. It is recommended that the sensor should not be applied to the
same finger for over 2 hours.
Measurement Limitation
During operation, the accuracy of oximeter readings can be affected by:
• High-frequency electromagnetic interference such as electrosurgical apparatus connected to the system.
• Intravenous dyestuff.
ENGLISH
Place SpO probe
2
probe cable into the USB socket in the lower right of the device.
2
interface.The update period of data is less than 5 seconds,
2
72