Tabla de contenido
Publicidad
Configuration setup
N.B.: The columns must always have an even number (minimum 4 and maximum 8)
A) New configuration
Only possible if the trolleys are all on the descent limit switches.
As first operation, to determine the MASTER column and the subsequent SLAVE columns.
1) When starting the switchboard, the following shall appear on the display:
> > L A S T C o n f i g
N E W
C o n f i g
L A S T
C o n f i g
> > N E W
C o n f i g < <
The following is displayed:
> > C o l
M A S T E R
C o l
S L A V E
> >
CANBUS CONN
W a i t
S l a v e s
to select/configure the SLAVE columns.
2) Shift to another column, when starting the switchboard the display shall show the following:
> > L A S T C o n f i g
N E W
C o n f i g
L A S T
C o n f i g
> > N E W
C o n f i g
the following is displayed:
> > C o l
M A S T E R
C o l
S L A V E
C o l
M A S T E R
> > C o l
S L A V E
Now the SLAVE column receives from the MASTER column the configuration message and the display shows:
> > C h a n n e l
C o l u m n
The operator should confirm the data pressing the black key "ENTER"
> > I D
2 C H
S e l e c t e d
N.B.: The operator must repeat the operations at point 2 for all columns of the power lift.
60
< <
move down with the blue Key
confirm with the black "ENTER" key
< <
determine the MASTER column by pressing the black "ENTER" key
2
< <
Now the display shows "Wait SLAVE", which means that the system is waiting for you
< <
move down with the blue key
< <
confirm with the black "ENTER" key
< <
move down with the blue button
< <
confirm the SLAVE column by pressing the "ENTER" black key
1
?< <
2
1
< <
confirm the correct configuration of the SLAVE 2 column
, to
, to
, to
; the following will be displayed:
0526-M002-3
(VARSC)
7
Publicidad
Tabla de contenido
