Tabla de contenido
Publicidad
If during the slow single descent the descent button is released while hLAST ing down the single button and the slow descent
button is pressed again, the cart descends without making a short ascent.
Parking, active on all columns, in ALL mode and
with the aligned carts.
GROUP operating mode
- for a bridge with 4 columns it is possible to only form a group of 2 columns
- for a bridge with 6 columns it is possible to only form a group of 2 or of 4 columns
- for a bridge with 8 columns it is possible to only form a group of 2, 4 or of 6 columns.
- it is not possible to access the group mode if the bridge is in parking,
or if the parking is not correct,
or if the column is moved in single mode (the bridge is not aligned),
NB: the power lift is unable to recognize that the group activated columns belong to the same axis, therefore this manoeuvre is per-
formed under the full responsibility of the operator. It is absolutely forbidden to activate group columns that are not of the same axis.
C) From "ALL" mode to "GROUP" mode
1) the display shows:
H e i g h t
1 1 1 1
the following is displayed:
> > 1 A l l
M o d e
2 G r o u p
M o d e
1 A l l
M o d e
> > 2 G r o u p
M o d e < <
the following is displayed:
> > G R O U P
R E Q ? < <
E x i t
Selecting the GROUP mode, the following is displayed:
> > G R O U P
M O D E
S E L E C T E D . .
If the GROUP mode is not available, the following is displayed:
> > G R O U P
M O D E
N O T
P O S S I B L E
2) repeat the operations on all the columns that you intend to enter in the group.
After selecting the GROUP function, the following shall appear on the selected columns:
H e i g h t
1 1 1 1
mm
A L L
Press the black "ENTER" key
< <
move down with the blue Key
confirm with the black "ENTER" key
confirm with the black "ENTER" key
< <
< <
mm
G R O U P
H e i g h t
P A R K i N G
H e i g h t
P A R K i N G
, to
0526-M002-3
(VARSC)
1 1 1 1
mm
O N
1 1 1 1
mm
K O
7
63
Publicidad
Tabla de contenido
