Nice Neomat T Instrucciones Y Advertencias Para La Instalación Y El Uso página 12

• The "multiple group" commands cannot be used with a transmitter memorized in Mode
II.
When one or more transmitters have already been memorized, others may be memorized
in Mode II as shown in table A16.
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Table "A16" - Memorizing additional transmitters in Mode II
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
01. Press and hold down the button to be memorized of the
5s.
new
new transmitter (for approx. 5 seconds) until you hear a
beep; then release it.
02. Within 5 seconds push and hold the button of an old and
5s.
old
already memorized transmitter (approx. 5 seconds) until
2 beeps are heard; then release the button.
03. Within 5 seconds start to push the same button of the
1- 4
new
old transmitter the same number of times equal to the
re quired command: 1="Step-by-Step" 2="Up" 3="Down"
4="Stop".
04. After about 3 seconds the same number of beeps as the
3s. 1- 4
selected command are heard.
05. Within 2 seconds push the same button of the new
new
transmitter.
06. Release the button when you hear the first of the 3
beeps confirming memorization.
If at point 5 the same number of beeps equal to the selected command are not heard,
simply do not push any more buttons and wait a few seconds for the programming to
finish without memorizing.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter can-
not be memorized.
A new transmitter can easily be memorized with the same characteristics as that of the old
one by following the procedure in table A17. The "new" transmitter will inherit the charac-
teristics of the old one, i.e. if the old transmitter was memorized in Mode 1, the new one
will also function in Mode 1, if the old transmitter was memorized in Mode II then the button
of the new transmitter will be associated to the same command as that of the old one.
10 – English
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Table "A17" - Memorizing other transmitters
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
01. Press and hold down the button to be memorized of the
> 3s.
new
new transmitter (for approx. 3 seconds) then release it.
02. Press and hold down the button to be memorized of the
> 3s.
old
old transmitter (for approx. 3 seconds) then release it.
03. Press and hold down the button to be memorized of the
> 3s.
new
new transmitter (for approx. 3 seconds) then release it.
04. Press and hold down the button to be memorized of the
old > 3s.
old transmitter (for approx. 3 seconds) then release it.
05. The memorization of the new transmitter is confirmed
with 3 beeps.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter can-
not be memorized.